How to Setup Encoders for Hollow
How to Setup Encoders for Hollow Shafts, The hollow encoder is another name for the hollow shaft encoder. Avoiding a rigid connection to the encoder is essential when installing this type of encoder. Regarding the installation shaft’s size, please refer to the instructions. The encoder should be gently pushed into the quilted shaft during installation. To avoid harming the encoder as a whole and the bearing, it is strictly forbidden to knock with a hammer. You should check to see if the encoder’s screws are loose after using a hollow encoder for a long time. The Hollow Shaft Encoder is installed. 1.1 Installation of the Hollow Encoder: Step One You ought to initially secure the drive shaft on the hardware and Don’t associate the encoder straightforwardly with the gear. An adaptable coupling is normally utilized. On the encoder, attach the coupling (1). If it’s not too much trouble, focus that the coupling doesn’t contact the encoder surface. Push the screw (3) and the servo clamp ring (2) onto the surface of the mounting flange without locking the screw. Turn the servo clasp ring (2) to push the encoder into place. Tighten the servo clamp ring (2) by rotating it into the servo sleeve. In order to guarantee that the installation error of the coupling and encoder is within the permissible range, fix the coupling on the drive shaft (1) and minimize the errors in angle and horizontal alignment. Secure the servo clamp ring’s three screws. 1.2 Installing the Hollow Encoder: Step 2 As the equivalent with the previous establishment strategy, you ought to initially attach the drive shaft on your hardware, and Don’t interface the encoder straightforwardly with the gear. Please use a coupling that can bend. Introduce the coupling (1) onto the encoder. Kindly focus that the coupling doesn’t contact the encoder surface. With the coupling (1), push the encoder into place. In order to guarantee that the installation error of the coupling and encoder is within the permissible range, fix the coupling on the drive shaft (1) and minimize the errors in angle and horizontal alignment. Attach the encoder to the flange for the mounting. Normal Issues of Empty Encoders and Arrangements